I went to New England Dragway Friday. First time this year and first time with my new mods.
DC JDM Header
Carsound cat
AEM CAI
I ran a 15.08 @ 92.7 MPH
and a 15.17 @ 93.2 MPH
Both with REALLY BAD wheel hop!!!
I was hoping to run a 14.7-14.8 I'm sure I will hit it next week. I had 3/4 of a tank of gas. I don't think that makes a huge difference. I didn't drop the pressure in my tires. Brigestone Potenzas 195/55/R15 Pole Position's
I got the Mods done a few days ago and I am still adjusting to the differences. I used to run Between 15.2-15-5
Went to NE Dragway Friday
-
- ITRCA Member
- Posts: 92
- Joined: January 7th, 2003, 6:59 pm
- Location: NH
-
- Senior ITRCA Member
- Posts: 825
- Joined: November 19th, 2002, 1:04 pm
- Location: City of Boost
- Contact:
times
What 60 foot? If you want any kind of traction out of the hole on street tires, don't burnout, and make sure your tire pressure is between 15 and 20, start at 20, and work your way down until you find the sweet spot.
http://speedindustry.biz
for all of your tuning, parts, fabrication and other service needs.
for all of your tuning, parts, fabrication and other service needs.
-
- ITRCA Member
- Posts: 92
- Joined: January 7th, 2003, 6:59 pm
- Location: NH
-
- Senior ITRCA Member
- Posts: 825
- Joined: November 19th, 2002, 1:04 pm
- Location: City of Boost
- Contact:
no burnout
I repeat, do not do a burnout with those tires, it will not do you any good, and lower the pressure.
http://speedindustry.biz
for all of your tuning, parts, fabrication and other service needs.
for all of your tuning, parts, fabrication and other service needs.
-
- Senior ITRCA Member
- Posts: 825
- Joined: November 19th, 2002, 1:04 pm
- Location: City of Boost
- Contact:
What? I cannot decipher this jibberish.sick tr wrote:I'm pury sure that you can do, what you want to do 14.7-14.8. because my best time is 14.6 and the only mod that I have is= JDM Header and CAI.
http://speedindustry.biz
for all of your tuning, parts, fabrication and other service needs.
for all of your tuning, parts, fabrication and other service needs.
-
- Senior ITRCA Member
- Posts: 825
- Joined: November 19th, 2002, 1:04 pm
- Location: City of Boost
- Contact:
What
I think your thought processes are probably in place, and in your mind you know what you want to say, but writing it down is just giving you some problems.
So what is it that you want to say?
So what is it that you want to say?
http://speedindustry.biz
for all of your tuning, parts, fabrication and other service needs.
for all of your tuning, parts, fabrication and other service needs.