Headgasket question
-
Gross_00-0088
- New ITRCA Member
- Posts: 64
- Joined: March 22nd, 2007, 1:26 am
- Location: Brownstown, IN
Headgasket question
I'm rebuilding my block right now and I have already ordered my pistons for a 81.25mm bore the problem is I can not find a headgasket for that bore anywhere. Every place I have went goes from 81.00mm to 81.50mm. I was wondering if the 81.50mm will be fine for my bore. If any one knows where I can find an 81.25mm bore head gasket ( Preforably Cometic) It would be greatly appriciated. Thanks
GROSS
-
Gross_00-0088
- New ITRCA Member
- Posts: 64
- Joined: March 22nd, 2007, 1:26 am
- Location: Brownstown, IN
-
Gross_00-0088
- New ITRCA Member
- Posts: 64
- Joined: March 22nd, 2007, 1:26 am
- Location: Brownstown, IN
-
Erik B
- Senior ITRCA Member
- Posts: 1029
- Joined: September 18th, 2002, 12:29 am
- Location: Cheyenne, WY
- Contact:
Re: Headgasket question
Why'd you go 81.25 on a rebuild?
2000 Turbo Integra Type R - 508whp/362lbs tq @ 21psi
2003 Imola/Imola NSX-T
http://www.jdmwhoreinc.com
2003 Imola/Imola NSX-T
http://www.jdmwhoreinc.com
-
Gross_00-0088
- New ITRCA Member
- Posts: 64
- Joined: March 22nd, 2007, 1:26 am
- Location: Brownstown, IN
Re: Headgasket question
I just just went up a little cuz I know I'm Going to redue it later on down the road. I just had to get it running again.
GROSS
Re: Headgasket question
King motorsports...call them...