Discuss national (except for the ITR Expo), regional and local events and meets here.
Little_Nolan
ITRCA Member
Posts: 451 Joined: December 18th, 2008, 7:11 pm
Location: NORFOLK/NOVA
Post
by Little_Nolan » January 18th, 2011, 2:15 pm
elambz wrote: Little_Nolan wrote: That sounds like a blast!
I went to the indoor range down the street from me the other day and shot my M&P.. long story short I was sweeping up my brass and got hit about an inch below the right eye with a piece of .223 jacket! it stuck into my skin and burnt me a little, more or less it scared the shit out of me and didnt do much real damage.
Damn dude. The only thing I don't like about Bob's is there's hardly any room behind the lanes. I had a brass land in the bridge on my glasses one time when I was shooting a Glock 17 and it burned a little when it stuck there. The other 50rnds all bounced off the top of my head, but luckily I had hair at that time.
Yeah I have brass hit me all the time aswell... I immediately knew this was not brass, it felt like someone flicked me REALLY hard in the face the second I heard a shot. I was bent down at the time and it scared the shit out of me. It took it a sec. to hurt and register but I reached up and pulled it out and sure enough if it wasnt a piece of FMJ
Pretty sure the cop next to me hit the target holder.
I KILL car thieves.
B18CXr
ITRCA Member
Posts: 324 Joined: June 5th, 2003, 12:33 pm
Location: Charlotte
Post
by B18CXr » January 22nd, 2011, 4:56 pm
I is ready for this..
Yack-
2002 Honda Challenge H1 Champion
Neptune, Apexi, AEM EMS certified tuner
Dave_B
Moderator
Posts: 9053 Joined: October 31st, 2005, 2:26 pm
Location: Post Whore!
Post
by Dave_B » January 23rd, 2011, 10:58 am
Joe, which route are you coming?
Any other NE'ers coming down?
98spec022
ITRCA Member
Posts: 285 Joined: November 18th, 2008, 8:59 am
Post
by 98spec022 » January 23rd, 2011, 11:10 am
As of right now no, but I'm hoping that changes!
Fatchance187
New ITRCA Member
Posts: 63 Joined: August 1st, 2008, 2:25 am
Location: Stevensville, MD
Post
by Fatchance187 » January 23rd, 2011, 11:32 am
I might be coming down... I have to get some car stuff figured out first.
Dave_B
Moderator
Posts: 9053 Joined: October 31st, 2005, 2:26 pm
Location: Post Whore!
Post
by Dave_B » January 23rd, 2011, 11:40 am
Cool, I might need a set of rims to travel back with one of ya if possible.
itrsteez
Half way to a cool title.
Posts: 2371 Joined: September 5th, 2006, 9:39 pm
Location: Strip Club Capital, North Carolina
Post
by itrsteez » January 23rd, 2011, 11:45 am
Can't wait for this
WTB: Gunmetal USDM ITR Wheels
Erik95LS
Banjo Viking
Posts: 6268 Joined: May 11th, 2003, 1:54 pm
Location: Where rock is criminal......criminals rock!
Post
by Erik95LS » January 23rd, 2011, 11:53 am
itrsteez wrote: Can't wait for this
x2
-Erik
"i sneezed and jam came out" - R-Box
coolhandluke
401R
Posts: 2489 Joined: December 12th, 2005, 2:36 pm
Location: SC
Contact:
Post
by coolhandluke » January 23rd, 2011, 12:45 pm
Fatchance187 wrote: I might be coming down... I have to get some car stuff figured out first.
Just say the word and I'm there to help. (as long as I'm not on call)
Erik95LS
Banjo Viking
Posts: 6268 Joined: May 11th, 2003, 1:54 pm
Location: Where rock is criminal......criminals rock!
Post
by Erik95LS » January 23rd, 2011, 12:48 pm
coolhandluke wrote: Fatchance187 wrote: I might be coming down... I have to get some car stuff figured out first.
Just say the word and I'm there to help. (as long as I'm not on call)
x2
-Erik
"i sneezed and jam came out" - R-Box
Doespike
Half way to a cool title.
Posts: 3542 Joined: April 2nd, 2006, 9:26 pm
Location: Buffalo, NY
Post
by Doespike » January 23rd, 2011, 1:24 pm
Dave_B wrote: Joe, which route are you coming?
Any other NE'ers coming down?
This route..12.5hrs
Linky
-Joe - ITR RegistRar
98-0309...Born 1/22/1998.
ITR Expo!
coolhandluke
401R
Posts: 2489 Joined: December 12th, 2005, 2:36 pm
Location: SC
Contact:
Post
by coolhandluke » January 23rd, 2011, 1:57 pm
12.5 hours = my old trip time for the Thanksgiving Meet.
13.5 hours = my old trip time for the PA meet.
This will be a weekend long event which makes it even better!
Dave_B
Moderator
Posts: 9053 Joined: October 31st, 2005, 2:26 pm
Location: Post Whore!
Post
by Dave_B » January 23rd, 2011, 2:05 pm
I'm taking the monday after off for recovery.
coolhandluke
401R
Posts: 2489 Joined: December 12th, 2005, 2:36 pm
Location: SC
Contact:
Post
by coolhandluke » January 23rd, 2011, 2:18 pm
Yeah our drive is going to be rough.....
In case I didn't post this, I have taken Friday off. Anyone is more than welcome to come in Friday during day.
Doespike
Half way to a cool title.
Posts: 3542 Joined: April 2nd, 2006, 9:26 pm
Location: Buffalo, NY
Post
by Doespike » January 23rd, 2011, 2:23 pm
Tentatively, I'm getting there Friday evening and leaving early Sunday...oh boy, haha
-Joe - ITR RegistRar
98-0309...Born 1/22/1998.
ITR Expo!
Dave_B
Moderator
Posts: 9053 Joined: October 31st, 2005, 2:26 pm
Location: Post Whore!
Post
by Dave_B » January 23rd, 2011, 2:26 pm
LOL, trooper Joe!!!
Erik95LS
Banjo Viking
Posts: 6268 Joined: May 11th, 2003, 1:54 pm
Location: Where rock is criminal......criminals rock!
Post
by Erik95LS » January 23rd, 2011, 3:13 pm
I'll probably run down friday afternoon
-Erik
"i sneezed and jam came out" - R-Box
coolhandluke
401R
Posts: 2489 Joined: December 12th, 2005, 2:36 pm
Location: SC
Contact:
Post
by coolhandluke » January 23rd, 2011, 3:31 pm
Jack's rolling in Friday as well.
elambz
I love tight jeans y0!
Posts: 706 Joined: May 9th, 2007, 10:29 pm
Post
by elambz » January 24th, 2011, 11:16 am
Looks like I won't be going to the meet anymore.
Gotta switch with my co-worker for this weekend so he can go to a trade show with his wife for her business.
2000 FBP ITR #0288
Doespike
Half way to a cool title.
Posts: 3542 Joined: April 2nd, 2006, 9:26 pm
Location: Buffalo, NY
Post
by Doespike » January 24th, 2011, 11:31 am
Sucks to hear mang......could yoo give the floor mat to Nate (if he dun mind) so he can bring to meat?
-Joe - ITR RegistRar
98-0309...Born 1/22/1998.
ITR Expo!
elambz
I love tight jeans y0!
Posts: 706 Joined: May 9th, 2007, 10:29 pm
Post
by elambz » January 24th, 2011, 1:00 pm
Doespike wrote: Sucks to hear mang......could yoo give the floor mat to Nate (if he dun mind) so he can bring to meat?
Yeah I can do that. I finally got a box I could fit it in without having to roll it up weird so I was gonna ship it out tomorrow at lunch but I can do either. I finally installed the floor mat retainer thing this weekend.
2000 FBP ITR #0288